FOCUS Enhancements FireStore FS-3 Manuale Utente Pagina 12
- Pagina / 44
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
PAGE 1
INSERTING AND REMOVING
FIRESTORE FSHDD-1
FIREWIRE DRIVES
The best way to get to know the FireStore
FSHDD-1 FireWire HDD is by studying
the supplied manual. The manual provides
detailed instructions and illustrations.
INSER
TING THE HDD: Insert the drive
into the slot on top of the FS-3 unit. Ensure that
the power switch on the bottom side of the
drive is set to “On” before inserting. The drive
will only insert one way and features a “key”
on one side to prevent incorrect insertion. Press
down on the drive handle firmly until the
handle meets the top of FS-3. If power is on,
you will observe the power LED light up green.
REMO
VING THE HDD: Slide the HDD release
latch on the FS-3 top plate toward the battery
system. Once slid as far as possible, hold the latch
while at the same time grasping the FSHDD-1
drive handle and pulling the HDD out from FS-3.
WARNING: Make sure FS-3 is in STOP mode
before removing the disk drive from the system.
Do not attempt to remove when FS-3 is in REC
or REC-PAUSE mode.
USING EXTERNAL FIREWIRE
DISK DRIVES
In addition to using FireStore FSHDD-1
FireWire HDDs in the internal slot on FS-3, it
is also possible to connect any FireWire disk
drive to the HDD I/O port on FS-3. Power a
single FireWire disk drive on FS-3 at any
given time (either internal or external). If
external drives are being used as additional
volumes to the inserted FSHDD-1 FireWire
HDD, it will be necessary to provide external
power to these drives. It may also be necessary
to partition and format drives before use with
FS-3. See page 31 of this user guide for
instructions on preparing drives before use.
NOTE: It is possible to “hot swap” both
internal and external FireWire HDDs on FS-3.
Drives can be disconnected and connected from
the system without the need to power cycle the
unit. Ensure that FS-3 is in ST
OP mode before
removing a disk drive.
PHYSICAL FEATURES
Y
our FireStore FS-3 features two main surfaces,
the front panel and the rear connector panel.
FRONT PANEL
The front panel contains the backlit LCD
and nine buttons for controlling FireStore’s
functions. The top row of buttons act as Soft
FireStore FS-3 User Guide
PAGE 11
- USER GUIDE 1
- IMPORTANT 3
- INTRODUCTION 8
- PACKAGE CONTENTS 8
- WHAT IS A DTE DISK RECORDER? 8
- WHAT IS FIRESTORE FS-3? 8
- BASIC APPLICATIONS 9
- MOUNTING TO A CAMCORDER 10
- FireStore FS-3 User Guide 10
- CONNECTING A FIREWIRE CABLE 11
- BETWEEN FS-3 AND CAMCORDER 11
- GETTING FIRESTORE RECORDED 35
- CLIPS ONTO A COMPUTER 35
- COMMANDERS 39
- FS-3 REMOTE CONTROL 39
- TECHNICAL SPECIFICATIONS 41
- MANL-0912-02 44
Prodotti e manuali riguardandi no FOCUS Enhancements FireStore FS-3
no FOCUS Enhancements 2.3 Manuale Utente
(15 pagine)
(15 pagine)
no FOCUS Enhancements DR-HD100 Manuale Utente
(114 pagine)
(114 pagine)
no FOCUS Enhancements FS-4 Manuale Utente
(120 pagine)
(120 pagine)
Sony CFD-RS60CP manuali
Manuali dei proprietari e guide per l'utente per no Sony CFD-RS60CP.
We fornisce 2 manuali pdf Sony CFD-RS60CP per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Commenti su questo manuale